Price range: £2,158.92 through £2,694.60
Universal Link G5 Neo4 ECU for up to six sequential cylinders or four with staged injection. Choose ECU only, ECU plus one DI Driver-4, or the official 2.5 m loom/sensor bundle. Custom wiring, setup and tuning required.
Typical lead time: 1–3 working days, subject to supplier stock.
Description
Link G5 Voodoo Neo4 universal wire-in ECU
The Neo4 brings flexible engine control and fast logging to a custom installation. Choose ECU only, ECU with a direct-injection driver, or the official loom-and-sensor bundle. Professional wiring, setup and tuning are required.
Useful features
- Up to six sequential cylinders or four with staged port/direct injection.
- Eight injector outputs, six ignition outputs and flexible shared I/O.
- GPS, Wi-Fi, Ethernet, dual CAN and USB-C communications.
- 1 GB logging and two H-bridges for supported throttle/actuator control.
- One onboard Lambda controller; a compatible sensor is required.
Choose your package
All options include the Neo4 ECU, USB-C cable, Wi-Fi and 4 m GPS antennas, dust covers, guides and stickers.
- 154-5000 – ECU only: no A/B loom, connector kit, external sensors or DI driver.
- 154-9000B – ECU + one DI Driver-4: adds one driver, its Superseal D plug/pin kit and USB-C cable. Supports up to four compatible solenoid DI injectors and one pump solenoid. No A/B looms or sensor pack; one driver is not a complete six-cylinder DI system.
- 154-9300B – ECU + wiring/sensors: adds 2.5 m A/B looms, Bosch LSU 4.9 with plug/pin kit, 4 bar absolute MAP and 1/8-inch NPT IAT sensors with connector kits. Uses onboard Lambda control; no separate CAN Lambda or DI driver.
Installation and support
This is a universal wire-in ECU, not a pre-tuned vehicle-specific replacement. Looms need custom termination. Direct injection requires compatible driver hardware and correctly characterised injectors/pump. Shared I/O functions must be planned individually.
Supplier unlock is required. Mount inside the cabin away from water, heat and ignition interference. Follow the Neo4 guide, full wiring manual within PCLink and applicable DI Driver manual. Installation must comply with local law and preserve required safety/emissions systems.
Custom wiring, installation, setup, dyno mapping and extra hardware are available separately by enquiry.
Additional information
| Package | ECU only, ECU + one DI Driver-4, ECU + 2.5 m A/B looms + sensors |
|---|---|
| ECU wiring & setup (PCLink) |







