Price range: £2,689.20 through £3,407.40
Universal Link G5 Neo6 ECU for up to eight sequential cylinders or six with staged injection. Choose ECU only, ECU plus one or two DI Driver-4 modules, or the official 2.5 m loom/sensor bundle. Custom wiring, setup and tuning required.
Typical lead time: 1–3 working days, subject to supplier stock.
Description
Link G5 Voodoo Neo6 universal wire-in ECU
The Neo6 brings flexible engine control and fast logging to a custom installation. Choose ECU only, ECU with a direct-injection driver, or the official loom-and-sensor bundle. Professional wiring, setup and tuning are required.
Useful features
- Up to eight sequential cylinders or six with staged port/direct injection.
- Twelve injector outputs, eight ignition outputs and flexible shared I/O.
- GPS, Wi-Fi, Ethernet, dual CAN and USB-C communications.
- 1 GB logging and two H-bridges for supported throttle/actuator control.
- One onboard Lambda controller; a compatible sensor is required.
Choose your package
All options include the Neo6 ECU, USB-C cable, Wi-Fi and 4 m GPS antennas, dust covers, guides and stickers.
- 156-5000 – ECU only: no A/B loom, connector kit, external sensors or DI driver.
- 156-9000B – ECU + one DI Driver-4: adds one driver, its Superseal D plug/pin kit and USB-C cable. Supports up to four compatible solenoid DI injectors and one pump solenoid. No A/B looms or sensor pack; one driver is not a complete six- or eight-cylinder DI system.
- 156-9200B – ECU + two DI Driver-4 modules: two drivers, each with its D plug/pin kit and USB-C cable. Each controls up to four compatible solenoid DI injectors and one pump solenoid. Confirm firing-order, timing and I/O requirements. No A/B looms or sensor pack.
- 156-9300B – ECU + wiring/sensors: adds 2.5 m A/B looms, Bosch LSU 4.9 with plug/pin kit, 4 bar absolute MAP and 1/8-inch NPT IAT sensors with connector kits. Uses onboard Lambda control; no separate CAN Lambda or DI driver.
Installation and support
This is a universal wire-in ECU, not a pre-tuned vehicle-specific replacement. Looms need custom termination. Direct injection requires compatible driver hardware and correctly characterised injectors/pump. Shared I/O functions must be planned individually.
Supplier unlock is required. Mount inside the cabin away from water, heat and ignition interference. Follow the Neo6 guide, full wiring manual within PCLink and applicable DI Driver manual. Installation must comply with local law and preserve required safety/emissions systems.
Custom wiring, installation, setup, dyno mapping and extra hardware are available separately by enquiry.
Additional information
| Package | ECU only, ECU + one DI Driver-4, ECU + two DI Driver-4 modules, ECU + 2.5 m A/B looms + sensors |
|---|---|
| ECU wiring & setup (PCLink) |








