Original price was: £1,350.00.£1,215.00Current price is: £1,215.00.
Link ECU choices for compatible manual Toyota MR2 SW20 / Celica applications. Select the exact wiring version. RC/Carlos Sainz uses TST205X; TST205X needs a suitable alternative enclosure on non-turbo cars. Installation and tuning required.
Typical lead time: 1–3 working days, subject to supplier stock.
Description
Link G4X MR2Link plug-in ECU
Select the ECU matched to your MR2 or Celica wiring version. These boards give your tuner programmable fuel, ignition and supported engine controls through PCLink, using the compatible factory loom. The two ECUs have different pinouts and must not be chosen by connector shape alone.
Useful features
- Programmable fuel and ignition mapping.
- Data logging to review engine operation.
- CAN communication with supported aftermarket equipment.
- Expansion connections for additional sensors and functions.
- PCLink software for configuration, logging and tuning.
Choose your vehicle version
TST185X, 221-4000: MR2 SW20 Rev1, 1989–1992, or Celica ST185 with 3S-GE/3S-GTE as listed by Link. The RC/Carlos Sainz special edition requires TST205X instead. Check the actual vehicle wiring against the installation manual.
TST205X, 222-4000: MR2 SW20 Rev2–3 from 1993, or Celica ST205 with 3S-GE/3S-GTE as listed by Link; also the GT-Four RC, Carlos Sainz and Group A Rallye special editions. This board does not fit the original non-turbo ECU housing: confirm a suitable enclosure before ordering for a non-turbo car.
Manual transmissions only. Confirm the exact engine, ECU wiring and vehicle version before ordering; these are not interchangeable universal Toyota ECUs.
Installation checks
Verify the actual injector impedance and ballast-resistor arrangement. Low-impedance injectors must not be connected directly. A suitable MAP sensor and calibrated intake-air-temperature sensor are required; do not assume the air-box/AFM temperature sensor is suitable for tuning. Additional sensors are separate.
Electronic throttle requires modification, an external controller, wiring and setup. CAN connections differ: TST185X has one CAN bus and TST205X has two. Use the correct cable and manual for the selected board.
Included and support
Your selected ECU board, anti-static strap, USB tuning cable, stickers, manual card and registration card. Retain the original compatible enclosure; case modifications may be needed. Sensors, expansion looms and throttle hardware are separate.
Professional installation, setup and tuning are required; a base map is not a finished tune. We offer installation, custom dyno mapping, sensor packs and custom wiring looms by enquiry. Link specifies off-road use; check your intended application. Read the TST185X manual or TST205X manual.
Additional information
| Vehicle version and ECU | MR2 Rev1 / Celica ST185 – TST185X (221-4000), MR2 Rev2–3 / ST205 / RC – TST205X (222-4000) |
|---|---|
| ECU wiring & setup (PCLink) |








