Original price was: £1,410.00.£1,269.00Current price is: £1,269.00.
Link K20X 237-4000 ECU for compatible manual Honda Integra DC5 / Acura RSX and the exact Civic/CR-V applications listed below. Original ECU case reused; installation, setup and tuning required.
Typical lead time: 1–3 working days, subject to supplier stock.
Description
Link G4X K20X plug-in ECU
The K20X replaces the factory engine-management board in compatible Honda and Acura applications. Your tuner can configure fuel, ignition and supported engine functions through PCLink while retaining the original ECU enclosure and factory loom.
Useful features
- Programmable fuel and ignition mapping.
- Onboard MAP sensing for engine-load measurement.
- Data logging to review engine operation.
- CAN communication with supported aftermarket equipment.
- Expansion connections for additional sensors and functions.
Exact supported applications
Manufacturer SKU 237-4000, also identified as HC20X/DC5 in Link documentation. Manual transmissions only. Match the factory connector and engine specification before ordering.
- Integra Type R DC5 and Acura RSX, 2002–2004: K20A/K20A2/K20A3 as listed by Link.
- Civic Type R EP3, 2001–2005: K20A.
- Civic Si/SiR, 2001–2005: K20A3.
- Civic DX/LX/HX, 2001–2005: D17A1/A2/A3.
- CR-V, 2002–2004: K24A1.
This is one ECU shared across these verified applications, not a universal Honda ECU. Other years, engines, markets and automatic models are not covered by this listing.
Installation and buying checks
Check the MAP-sensor jumper and calibration for the actual factory or onboard sensor, and configure the intake-air-temperature input. Electronic-throttle conversion needs the dedicated expansion connector, appropriate hardware, wiring and setup. Staged injection requires additional wiring.
Correct serial-port configuration is essential for the factory dash and immobiliser communication. Link notes that the immobiliser light may continue flashing and advises technical support in that case. The powered four-pin CAN connection needs the appropriate cable; the older CANPCB cable is incompatible.
Included and support
K20X ECU board, anti-static strap, USB tuning cable, stickers, manual card and registration card. Extra sensors and expansion looms are separate. Professional installation, configuration and tuning are required; the base map is not a finished tune.
We offer installation, setup and custom dyno mapping by enquiry, with sensor packs and custom wiring looms available separately. Link specifies off-road use; check suitability for your intended use. Read the K20X/HC20X installation manual before installation.
Additional information
| ECU wiring & setup (PCLink) |
|---|






