Original price was: £1,374.00.£1,236.60Current price is: £1,236.60.
Link ECU choices for compatible manual RX-7 FD3S 13B-REW models. Select Series 6 or 7/8. Factory sequential twin-turbo control is not supported. Installation, setup and tuning required.
Typical lead time: 1–3 working days, subject to supplier stock.
Description
Link G4X ECU for Mazda RX-7 FD3S
Select the ECU matched to your RX-7 series and factory connector. These Link plug-in boards replace the compatible original ECU board and reuse its enclosure, giving your tuner control over fuelling, ignition and supported rotary-engine functions.
Useful features
- Programmable fuel and ignition mapping.
- Data logging to help review engine operation.
- Support for the factory metering oil pump when correctly configured.
- Connections for supported additional sensors and functions.
- PCLink software for setup, logging and tuning.
Choose the correct series
RX7S6X, 218-4000, is for FD3S Series 6 with 13B-REW engine. RX7S7X, 219-4000, is for FD3S Series 7 or 8 with 13B-REW engine. Manual transmissions only. Check the factory connector against the photograph; the two boards are not interchangeable simply because both are for an FD RX-7.
Factory sequential twin-turbo control is not supported. Link lists naturally aspirated, parallel-twin and single-turbo configurations. Confirm the engine and turbo conversion with your installer before ordering.
Installation checks
The metering oil pump must be set up and tested correctly to maintain engine lubrication. Verify the actual injectors; low-impedance injectors need suitable ballast resistors. Check MAP/IAT sensor selection and calibration. Electronic-throttle conversions need extra hardware and wiring; confirm the requirements for the exact board revision. The Series 7/8 CAN connections also vary with PCB revision.
Included and support
Your selected ECU board, anti-static strap, USB tuning cable, stickers, manual card and registration card are included. Additional sensors, expansion looms and throttle-conversion hardware are separate. We offer sensor packs, custom wiring looms, installation, setup and custom dyno mapping by enquiry.
Professional installation and tuning are required. The supplied base configuration is a setup starting point, not a finished tune. Link specifies off-road use; check your intended application. Follow the exact Series 6 manual or Series 7/8 manual.
Additional information
| Series and ECU | Series 6 – RX7S6X (218-4000), Series 7/8 – RX7S7X (219-4000) |
|---|---|
| ECU wiring & setup (PCLink) |








