Original price was: £126.00.£113.40Current price is: £113.40.
Link 101-0054 KNSB non-resonant knock sensor, pre-wired with a 2.6 m loom and flying leads. For compatible Link and aftermarket ECU knock inputs. Supplier stock was zero at the latest check, so backorders are disabled.
Out of stock
Description
Link knock sensor with loom (KNSB)
The Link 101-0054 KNSB is a non-resonant piezoelectric knock sensor supplied pre-wired with a 2.6 m loom and flying leads. It monitors engine-block vibration and sends the signal to a compatible ECU so knock can be identified and the calibration can use suitable knock-control and engine-protection strategies.
What is included
- Link KNSB non-resonant knock sensor
- Pre-wired 2.6 m loom
- Flying leads for connection to the engine-management system
Compatibility
Designed for Link ECUs with knock-detection capability. It can also suit other aftermarket ECUs with a compatible knock-sensor input and can be used with the Link KnockLink visual warning light where the installation and wiring are suitable.
Installation and setup
Install the sensor directly onto a suitable flat surface on the engine block. Link specifies a tightening torque of 20 ± 5 Nm; correct mounting and torque are critical for reliable knock detection. Wire the flying leads to the correct input and configure the sensor in the ECU software. One or more sensors may be required depending on the engine and application.
Before ordering
Confirm the ECU input, sensor quantity, mounting position and wiring requirements for the exact application. This is a universal motorsport sensor rather than a vehicle-specific replacement. Professional installation and ECU calibration are recommended. MB Developments can help with installation, setup and custom dyno calibration by enquiry.
Manufacturer part number: 101-0054
Additional information
| Weight | 1 kg |
|---|---|
| Dimensions | 25 × 20 × 10 cm |
| Manufacturer part number | 101-0054 |
| Sensor type | Non-resonant piezoelectric knock sensor |
| Included loom | Pre-wired 2.6 m loom with flying leads |
| Mounting style | Donut-style engine-block knock sensor |
| Tightening torque | 20 ± 5 Nm |
| ECU compatibility | Link ECUs with knock detection; suitable aftermarket ECU knock inputs |
| ECU wiring & setup (PCLink) |








