Original price was: £157.20.£141.48Current price is: £141.48.
Variable-reluctance crank sensor for suitable steel trigger wheels. Includes the matching plug, pins and boot. Use shielded wiring, set the gap at around 0.5 mm and configure the trigger correctly in PCLink; not recommended as a cam sensor.
Typical lead time: 1–3 working days, subject to supplier stock.
Description
Link crank angle sensor (CAS)
The Link 101-0025 crank angle sensor is a variable-reluctance (VR) sensor used with a steel trigger wheel to measure crankshaft position. A clean, correctly configured crank signal gives the ECU the engine-speed and position information it needs for accurate ignition and fuel control.
What is supplied
- Link VR crank angle sensor
- Matching Bosch-style plug, pins and boot (Link connector kit 101-0051)
Application and setup
This universal sensor can be used with almost any suitable steel trigger wheel fitted to the crankshaft. It requires correct mechanical mounting, trigger-wheel geometry, wiring and ECU setup; it is not a vehicle-specific plug-and-play replacement.
- Use shielded signal wiring and route it away from electrical noise.
- Set the sensor gap at around 0.5 mm, then confirm a stable trigger signal.
- Configure and verify the trigger pattern in PCLink before running the engine under load.
- This sensor is not recommended for the cam signal.
Before ordering
Check the trigger-wheel material, tooth pattern, mounting position and wiring requirements for your ECU and engine. Depending on the ignition strategy, a separate cam/Trigger 2 sensor may also be required; Link part 101-0280 is the current Hall-effect sensor kit. Professional installation, setup and tuning are recommended.
Additional information
| Manufacturer part number | 101-0025 |
|---|---|
| Sensor type | Variable reluctance (VR) |
| Application | Crankshaft position with a suitable steel trigger wheel |
| Typical sensor gap | Around 0.5 mm |
| Wiring | Shielded signal wiring required |
| Included | Sensor, matching plug and pins |
| ECU wiring & setup (PCLink) |








