Original price was: £2,272.00.£2,160.00Current price is: £2,160.00.
Haltech HT-220205 Nexus Rebel JZ ECU kit for supported Toyota 1JZ/2JZ manual-transmission installations. Includes the terminated JZ harness package, sensors and adaptors listed below. Professional installation and calibration are required. Temporarily out of stock in the UK; contact us for current availability.
Out of stock
Description
Haltech Nexus Rebel JZ ECU kit
The Nexus Rebel JZ is a complete Haltech engine-management package for supported Toyota 1JZ and 2JZ manual-transmission installations. It combines the Rebel JZ ECU with the terminated engine harnesses, sensors and adaptors needed for the applications listed below. Professional installation, setup and calibration in Haltech NSP software are required.
Supported engine applications
- 1JZ-GTE non-VVT-i
- 1JZ-GE VVT-i
- 1JZ-GTE VVT-i
- 2JZ-GTE non-VVT-i
- 2JZ-GE VVT-i
- 2JZ-GTE VVT-i
Manual transmissions only. The kit is supplied with an R154 transmission harness. Check the exact engine, throttle, ignition, injector and vehicle integration before ordering.
Kit contents
- Nexus Rebel JZ ECU and main terminated harness HT-186400
- Denso, Bosch and Tundra alternator harnesses
- R154 transmission harness HT-187005 and cable-throttle sub-harness HT-186160
- i6 EV1 injector harness HT-186004 and i6 R35 coil-on-plug ignition harness HT-186063
- Bosch LSU 4.9 oxygen sensor, Haltech air-temperature sensor, two Bosch knock sensors and adaptors
- 150 psi oil-pressure sensor with 1/8 BSPT-to-1/8 NPT adaptor
- USB-C cable, Wi-Fi antenna, mounting hardware, power terminals and boots
Important limitations
This kit does not support Toyota ETCS-i semi drive-by-wire, distributor ignition, wasted-spark ignition, low-impedance injectors, the factory sequential twin-turbo arrangement or the original 1JZ coolant-temperature sensor. The supplied ignition harness is for an R35 coil conversion; the optional HT-120200 coil/bracket kit is sold separately.
Resources and delivery
See the official Haltech Nexus Rebel JZ knowledge-base article before installation.
Haltech sale: dispatch times may be longer than usual. Please contact us before ordering to confirm current availability and estimated delivery. The supplier currently shows this kit temporarily out of stock in the UK, so backorders are disabled on this listing.
Additional information
| Supported engines | 1JZ-GTE non-VVT-i; 1JZ-GE/GTE VVT-i; 2JZ-GTE non-VVT-i; 2JZ-GE/GTE VVT-i |
|---|---|
| Transmission | Manual only; R154 transmission harness included |
| Manufacturer part number | HT-220205 |
| Setup & support | Professional installation and Haltech NSP calibration required |










