Original price was: £2,106.00.£1,895.40Current price is: £1,895.40.
Link G5 ECU for compatible FA20 Toyota 86/GT86, Subaru BRZ and Scion FR-S. Select RHD 241-4000 or LHD 241-4200; mounting differs. Manual and automatic supported. Board-revision checks, installation and tuning required.
Typical lead time: 1–3 working days, subject to supplier stock.
Description
Link G5 GT86 plug-in ECU
Configure fuelling, ignition and supported engine functions through PCLink while retaining the factory ECU location and loom. This G5 ECU controls the FA20’s direct and port injection, with built-in electronic-throttle control for a compatible original installation.
Useful features
- Direct and port injection control.
- Built-in drive-by-wire control.
- Dual CAN buses for compatible equipment.
- 512 MB onboard data logging for setup and diagnosis.
- Configurable engine protection, flex-fuel and boost-control functions with suitable sensors, hardware and tuning.
Choose the correct hardware
Select right-hand drive 241-4000 or left-hand drive 241-4200. Their mounting arrangements differ; they are not interchangeable purchase choices. Supported applications are Toyota 86/GT86 ZN6, 2012–2021, and Subaru BRZ ZC6, 2012–2020, with the FA20/4U-GSE engine. The LHD version also supports Scion FR-S 2012–2016. Both manual and automatic transmissions are supported. Match the actual ECU connectors and steering position before ordering; this is not a GR86 or second-generation BRZ listing.
Important installation checks
For 2017-on cars, confirm the ECU board revision before ordering. Revision 05 or newer uses the appropriate PCLink sample map; revision 04 or earlier requires the crank-sensor and DI fuel-pressure wiring/configuration changes detailed in the manual. Map selection also depends on key-start versus push-button start. No particular stock-board revision is promised.
The factory wide-range AFR sensor is unsupported; Link recommends a separate aftermarket wideband system. Facelift LIN alternator and battery-sensor communication is unsupported. ABS/check-engine lights can appear after storing a tune; follow the manual’s guidance. For boosted conversions, the original MAP sensor needs upgrading.
Setup and support
This choice supplies the selected ECU; additional sensors, wideband equipment, expansion looms and conversion hardware are separate. Professional installation, configuration and tuning are required. A base map is a starting point, not a finished tune. Read the G5 GT86 installation manual.
We offer installation, setup and custom dyno mapping by enquiry, plus separately supplied sensor packs and custom wiring looms. Link specifies off-road use; confirm suitability for your intended application.
Additional information
| Steering position | RHD – 241-4000, LHD – 241-4200 |
|---|---|
| ECU wiring & setup (PCLink) |








